Arlong came out unscathed from Luffy's brutal combo of pistol, gatling gun and bazooka.While Krieg's crew only been fighting against less skilled marine soldiers from the East blue and only had the numbers and military strength on their side.
Considering that the Arlong's pirates used to be crewmates under fisher tiger's crew, meaning they fought against many professional marine soliders from the Grandline for years and made themselves known to the point where the marine gave them a bounty individually.Krieg pirates are healthy and not starving.Arlong Pirates have access to water (the parks large pool area) but Krieg pirates are fully aware of Fishmen underwater strength.In this situation, Arlong was distracted with bullying villagers and Krieg was able to make it into Arlong Park with his crew after blowing up the walls and gates surrounding the park. Usually, Arlong would destroy ships that came close to shore on his territory.But even if you do need it, manually moving the lever in the cockpit with your mouse should still work, because again you don’t have any spoilers axis assign to override it.Scenario: Krieg defeats the Strawhat pirates, stealing the Baratie and making his way into Cocoyasi Village after hearing word of a fishman pirate ruler with a higher bounty than him. But frankly, I never needed do that for my flights anyway. The only drawback here is that you can’t apply half spoilers or any level of spoiler that you want.
Same goes for the other way around, if you want to manually deploy the spoilers, just keep pulling it, and it will disarm the spoilers back to the retract position, and if you keep pulling it, it will deploy full spoilers. When you want to disarm the spoiler, just push it up to the retract position, and the sim will retract the spoilers and disarm it. So pulling the lever to the first detent, will arm the spoiler and there’s no axis positions to override it. But since your spoiler position is in the retract position, it will not deploy at all because the retract position overrides the auto-spoilers.īy removing the axis altogether, the position of the spoiler axis will no longer override whatever spoilers input that you have. The fact is, the position of your spoilers lever in axis mode will override any other spoilers input that you have. I do it this way, because while having the Axis seems like a great idea to control the amount of spoilers you want to deploy. I put everything to digital inputs myself.Īt the up position, it activates the Retract Spoilers command.Īt the first detent, it activates the Set Spoilers ArmingĪt the second detent in the middle, it also activates the Spoilers Retract Command.Īt the third detent, it triggers the RZ Axis- to Extend Spoilers command.Īt the final detent, the virtual button is also bound to the Extend Spoilers command. I had to remove the spoilers axis from the spoiler lever because it interferes with the Auto-Spoilers arming. You need to make sure that the virtual buttons that are engaged by the spoiler lever detents are not affecting the spoilers deployment. I’m actually pretty desperate at this point…maybe someone has another idea to help me out. Inside the system control everything is working (although I noticed the spoiler lever is associated with buttons 27 - 31 inside the system control). I got firmware 1.61 installed, T.A.R.G.E.T. I have rebooted the computer, restarted the sim at least ten times. Inside the binding menu, the spoiler lever works. It’s assigned correctly to the R-Z Axis as it is in the default settings (I checked and re-checked, axis inverted as well). Everything works fine, every button, every lever. Yes, all 5 positions, pushing the red buttons five times, holding the black button to get it into config mode and holding both to get the controller out of config mode. I have tried the solution that Neo posted about everywhere on the board at least 10 times. Again, now me, with this annoying TCA controller.